WANTED! Anyone with a guard roller and rolling experience

[evil1]

anyone wanna help a brother out?
i just need one of my guards rolled
the tiny bit of rubbin is starting to bother me big time.
anyone helpage?

[Nickevox]

Dez - 0412 034 861
Autofx.. did my car and cips sil80.. does good work... only like 100bucks for both rears

[AGIT8D]

heat gun and metal dolly wrapped in a rag, DIY.

Keep the paint warm so it doesn't crack and massage it with whatever you have that'll bend the guard up without bashing it and kinking it (not exactly easy to do) You want to go for (as example) 50 hits to gain 1cm not 1 hit to gain 5cm clearance...

Hair dryer may work for paint but haven't tried it personally.

[Mistikal]

Tech9 also do it cheap, had it done on the Calais, good job :)

[evil1]

heat gun and metal dolly wrapped in a rag, DIY.

Keep the paint warm so it doesn't crack and massage it with whatever you have that'll bend the guard up without bashing it and kinking it (not exactly easy to do) You want to go for (as example) 50 hits to gain 1cm not 1 hit to gain 5cm clearance...

Hair dryer may work for paint but haven't tried it personally.

sounds dangerous hahaha

[AGIT8D]

Na, it's not that bad :) Saves spending money getting someone else to do the exact same thing (this is how most panel shops etc roll your guards) or to bolt on a guard roller and HANG off that with the heat gun on the paint to do the same thing.

If it's only just rubbing and only on one side you aren't going to need to give it much to clear.

[Big Cam]

I have guard roller, come around with some beer and ill drink it while you roll guards.

[evil1]

done