Twin Side Draught Webers

[feznutz]

any know how to tune em or a rough idea on a basic setting for me to work from ?

they are twin 40's fitted to a 2 litre escort

[bmgtz]

any know how to tune em or a rough idea on a basic setting for me to work from ?

they are twin 40's fitted to a 2 litre escort

whilst I havent turned a hand to tuning efi.....I have done heaps of webers and could help.

pm me a list of the components in your current set up.....mains, emulsion tubes,air corrections, idle jet. pumps also the chokes and aux veturis

along with some brief specs of the engine.....big cam,,,head work etc

brian

[feznutz]

they are soft mounted aswell,i might get rid of the o ring and just use a normal gasket and hard mount them on to the redline manifold

[datsqik]

http://teglerizer.com/dcoe/index.html
There is a MS-DOS based jetting programe thats not bad as a starting point. Its about half way down the page by dave andrews.

[bmgtz]

they are soft mounted aswell,i might get rid of the o ring and just use a normal gasket and hard mount them on to the redline manifold


be careful doing that, it is very easy to break the lugs off a dcoe

[feznutz]

i was lookin at a lot of articles and pics and most of them seem to be soft mounted,im gonna get new o rings and keep em that way i think

[bmgtz]

that is the best way to go.....but again make sure you tighten them down evenly.