PDA

View Full Version : RB34


Alt_F4
27-12-2009, 11:43 PM
RB34 Stroker for the RB30 from Spool :yum:

http://www.spoolimports.com/content/files/RB34.JPG
http://www.spoolimports.com/content/SPOOLNISSANRB30STROKERCRANK.asp
Lonewolf
27-12-2009, 11:48 PM
95mm stroke, would make nice torque but not want to rev too hard
Alt_F4
28-12-2009, 12:22 AM
I'd imagine it'd be around 7500rpm like the 2jz 3.4L kits, plenty of revs to be had
WHITER33
28-12-2009, 07:45 PM
Price....?
DR1FT3N
28-12-2009, 07:49 PM
:eek3: do want!!!
Sleekman
12-01-2010, 10:52 PM
I think spool said price is around the 6-7k mark depending on exchange rates
Alt_F4
12-01-2010, 11:09 PM
I think spool said price is around the 6-7k mark depending on exchange rates
Price was $5900... price will only go higher if the dollar goes to shit again.

Also I found out the block needs to be machined to clear (no big deal), but spool is also considering a lower stroker (~93mm) that will be a complete drop in
cactus
13-01-2010, 10:05 AM
I should have waited a couple of months lol
Joe
13-01-2010, 10:09 AM
Thats cheap!

If you want to be a baller though, you need an OS Giken RB315.

http://www.otomoto.com.au/osgiken/rb30kit.gif

I can source these for a hair over $25,000, plus the OS Giken clutch required to work with it.
Alt_F4
13-01-2010, 11:32 AM
Thats cheap!

If you want to be a baller though, you need an OS Giken RB315.

I can source these for a hair over $25,000, plus the OS Giken clutch required to work with it.
I'd take a RIPS built bottom @ ~$10K end over a $25K OS3L.

Nothing special about the OS30, other than it gives a worse rod/stroke ratio than the rb30.