Wheel centre boring

[dmwill]

Found some rims I am keen on finally, though it would appear that the centre bore/hole on the rims are smaller than my current ones. Current rims being, 67.1mm and the ones I want, 64.1mm.

Assuming I need to get them bored out to the right size, who does this kind of work and at what cost? Prefer NOR.

[stumps.]

Holden rims?

http://www.highlandwoodworking.com/ProductImages/scraping/032447.jpg

Take the lip off good to go

[AGIT8D]

Are your current wheels the factory wheels?

[dmwill]

Current rims are factory Mazda rims, looking at some 8th Gen Civic Sports 17"s (I believe they also came on the EP3 Type R as well).

[dmwill]

Anyone? :(

[Lump]

i know this guy does them but he's in bently-

Rob Faulkner at Perth Rim Repair

just about any machine shop would be able to do this, going on a quote i got from Rob for some work, im guessing he would charge about $200 or more, but give him a call to discuss.

[R3N]

check the wheel repair thread and give them a call and ask?

[AGIT8D]

Correct any machine shop should be able to do it, just a matter of locating one. Lots of VT-VZ guys use VE wheels and have them milled to fit, about $50/wheel.

[Risk10k]

I've got a lathe big enough to turn them on, couldn't see it being a problem.

[dmwill]

Did a bit of a search and found a few people who have got VE rims bored out to fit earlier models at a place in Cannington (Gommers Leo Engineering) for $35 a rim. Will confirm tomorrow :)

[Mr Scorpio]

Leo Gommers is indeed cheap and fast, I use him quite a bit.

Performance Modifications in Osborne Park is also very good and is a bit further NOR for you.