PDA

View Full Version : Lowered springs to suit VR-VS with IRS


Brett_J
15-05-2011, 09:44 PM
As title states looking for lowered springs,must be to suit IRS.

Cheers
Brett_J
17-05-2011, 05:04 PM
I need wine to feed my family, who are you to resist!

Also my car scrapes clouds, needed asap!
mys1
17-05-2011, 05:07 PM
http://www.cuttingtoolssite.com/wp-content/uploads/2011/04/angle-grinder-1.jpg
Brett_J
17-05-2011, 06:56 PM
Easy tiger, its not a shitter RX7 !
I would but it has King Springs in there that are standard height, be good when I go over the pits when it eventually gets a yellow.
Splat_man
17-05-2011, 10:11 PM
http://www.cuttingtoolssite.com/wp-content/uploads/2011/04/angle-grinder-1.jpg

NOR likes this.
Mistikal
18-05-2011, 02:24 AM
FYI, VT-VY (think front strut in VY2 is different for some reason? I could be wrong) all fit too - F&R.
Philbo
18-05-2011, 09:37 AM
Swap your stockish struts for some slammed ssls ?
wormbo2
18-05-2011, 01:21 PM
FYI, VT-VY (think front strut in VY2 is different for some reason? I could be wrong) all fit too - F&R.

So what you're saying is that a set of VX FE2 standard springs, will fit his vehicle to the desired height he so wishes?!

If so, Brett J, I'm your man! Set fresh out of the car last weekend.
Can have em for beer
blackjack
18-05-2011, 01:28 PM
To lower a late model commodore (not VE) VS springs can be used (BMW in the rear for real low) but if you put latter model springs in a VS it's likely to raise it !!
So just double check.