PDA

View Full Version : water proofing rb30 dizzy



87VLC26
01-08-2011, 10:12 AM
Went to kwinana off road area cnr of thomas and rockingham rd on saturday was great fun,

puddles were well deep and the 30 in my gu went well allday untill i was in a puddle for a bit to long and the dizzy got flooded, ]

whats the best way to waterproof them if you can.

going again in 2 weeks (few redo's and fixups on the 4bies) if crew are keen to tag along we had 5 cars on the weekend be good to get few more down.

Bogrolls
01-08-2011, 10:53 AM
put vaseline on it my chev dizzy gets lubed up like 18" dildo if i wanna smash mudpit puddles without involuntary cylinder deactivation.

Rheezy
01-08-2011, 12:33 PM
Use denso tape

[Jacek]
01-08-2011, 12:35 PM
Always wondered about this - so you guys will tape them up/lube them up and then remove it all after you're done attacking the water? Or is it fine to keep on there for daily driving etc?

mr_mike
01-08-2011, 01:19 PM
Some sort of grease on all gaps or connections should be enough to seal it.
Smash up some pics of ur rb30 GU, any other mods? My rb30 GQ struggled a bit down Harvey on sunday but that was on 33's at 15psi and 4 people in there

87VLC26
01-08-2011, 02:25 PM
sweet as, will just get the vaso and duct tape from under my bed :S

rb30e, 2.5 inch exhaust, 35 stt's, 4 inch lift, heavy duty flywheel and 6 puk clutch, still runs the 2.8l radiator, some spoties that now dont work :)

http://i230.photobucket.com/albums/ee168/deevochops/002.jpg

http://i230.photobucket.com/albums/ee168/deevochops/patrol.jpg

ovaxitd
01-08-2011, 02:37 PM
How did the Navara go ??

87VLC26
01-08-2011, 03:23 PM
the nav went well stayed outa these sorta puddles as it was stock but was in 2wd most the time and no trouble.