4g63t bellhousing pcd

[daedalusjc]

hi guys,

the 4g15t from the colt finally spat a rod when an experiment with sequential ignition went wrong due to a noisy trigger. i cant really be fucked putting another stock motor in as the 63 seems far better suited to producing good power. I need to check the pcd of the gearbox bolts to see if they Will come close to bolting up to the stock gearbox otherwise i might have to chuck another box in to suit. Does anyone have an evo 4g63 engine or gearbox laying around that i might be able to take some measurements from if possible or even a cad drawing etc?

cheers

[bmgtz]

I have some early 4g63s....vr4 and evo 123.

[daedalusjc]

ok awesome. Im assuming that except for the north south motors and 4b11 that the bolt pattern would be the same. would it be possible to come and have a measure up one day you are free?

[bmgtz]

4g93 is the same...

you could drop by over the weekend...or up till Wednesday. After that Im away till july and family wont be much help to you

[daedalusjc]

sweet will send you a text. thanks for that

[Pete]

I have some early 4g63s....vr4 and evo 123.

Being someone with the knowledge you've got, won't he have to use a certain block for the engine mounts ? like some shells will take the evo block, but others will take the vr4 ?

[bmgtz]

VR4 1G 6bolt engine has roll stopper mounts on the block....where as the evo1,2 and 3 {2g] block doesn't...those mounts are on the bell housing.

both blocks are here...will chat about what is going to work best