Brake line tee piece

[Daveo]

Hey guys,

Im chasing a fitting which will go into my R32GTR brake master cyclinder which then splits the line to two. So a male thread which goes to two female threads. Ive tried Enzed with no luck and called a few places. Any idea where I could get something like this?

Thanks,

Dave

[blackjack]

http://www.couplers.com.au/

[DISTRBD]

Hey guys,

Im chasing a fitting which will go into my R32GTR brake master cyclinder which then splits the line to two. So a male thread which goes to two female threads. Ive tried Enzed with no luck and called a few places. Any idea where I could get something like this?

Thanks,

Dave

Any decent parts supplier should have on the shelf .

[dattoman]

Actually... since you will probably want metric threads... no not too many will have it
I don't know of a male - 2x fem adaptor

There are such things in imperial threads I recall
So... keep looking

Or you could buy a 3 way metric female T piece and make a short steel pipe from T to master cyl outlet

[DISTRBD]

Actually... since you will probably want metric threads... no not too many will have it
I don't know of a male - 2x fem adaptor

There are such things in imperial threads I recall
So... keep looking

Or you could buy a 3 way metric female T piece and make a short steel pipe from T to master cyl outlet

Not so much a T but banjo fitting with twin outlet . Used on some vechile master cylinders already .

[dattoman]

Yep thats another way to go for sure
Many old Toyotas ran that on single line masters

[DISTRBD]

Yep thats another way to go for sure
Many old Toyotas ran that on single line masters

Yea just need to find some switched on parts guru , you should do retail again :P

[SINISTR]

Dave - try CBA in Malaga www.cbaus.com.au

I recently got some T's for my cae when installing the proportioning valve, they might have something there that would suit.

[dattoman]

Yea just need to find some switched on parts guru , you should do retail again :P

If only I could find a job that paid well .... and gave me freedom to have some fun

[DISTRBD]

If only I could find a job that paid well .... and gave me freedom to have some fun

Can't have both :P

[dattoman]

OK... just paid better then

If I could get back on the mines I'd start doing some special stuff on my weeks off for fun

[Sack]

Couplers can make you one up. It would be a female T piece and then they can braze on a male fitting to one of the female ports. I've had this done on my 86 to run and aftermarket oil pressure sender from factory spot in block.

[Daveo]

Thanks for the replies guys.. .I'll give CBA a shot tomorrow.. the thread is a m10 with a 1mm pitch... hopefully they'll be able to help me out.
Cheers

[Daveo]

I had some luck today, Steph from Perth Brake Parts had the T piece I require and was very helpful.